Kyocera FS-C8520MFP - Setting System 1

2MY/2MZ
1-3-100
U610 Setting system 1
Description
Makes settings for fax reception regarding the sizes of the fax paper and received images and
automatic printing of the protocol list.
Method
1. Press the start key.
2. Select the item to be set.
Setting the number of lines to be ignored when receiving a fax (A4R/LetterR) in the auto
reduction mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode onto A4R or LetterR paper
under the conditions below.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1. Change the setting using the cursor left/right keys or numeric keys.
* : Increase the setting if a page received in the reduction mode is over-reduced and too
much trailing edge margin is left. Decrease it if the received image does not include all
transmitted data.
2. Press the start key. The value is set.
Setting the number of lines to be ignored when receiving a fax at 100% magnification
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when recording the data at 100% magnification. If the number of excess lines is
below the setting, those lines are ignored. If over the setting, they are recorded on the next page.
1. Change the setting using the cursor left/right keys or numeric keys.
* : Increase the setting if a blank second page is output, and decrease it if the received
image does not include the entire transmitted data.
2. Press the start key. The value is set.
Item No. Description
Display Description
Cut Line:A4 Sets the number of lines to be ignored when receiving a fax
(A4R/LetterR) in the auto reduction mode.
Cut Line:100% Sets the number of lines to be ignored when receiving a fax at
100% magnification.
Cut Line:Auto Sets the number of lines to be ignored when receiving a fax in
the auto reduction mode.
Description Setting
range
Initial
setting
Change in
value per step
Number of lines to be ignored when
receiving a fax (A4R, letter) in the auto
reduction mode
0 to 22 0 16 lines
Description Setting
range
Initial
setting
Change in
value per step
Number of lines to be ignored when
receiving at 100%
0 to 22 3 16 lines