2MY/2MZ
1-5-30
4. Remove all connectors from DP main
PWB.
5. Remove five clamps and then remove
the waires from holder.
6. Remove two screws and then remove
the holder.
Figure 1-5-54
7. Remove six screws and then remove
the DP main PWB.
8. Check or replace the DP main PWB
and refit all the removed parts.
CAUTION: When replacing the DP
main PWB, remove the EEPROM from
the DP main PWB that has been
removed and then reattach it to the new
DP main PWB.
Figure 1-5-55
Clamps
Wires
Holder
Screw
Screw
DP main PWB
Screw
Screw
Screw
Screw
Screw
Screw
DP main PWB
To Next Page
Loading...
