Kyocera FS-C8520MFP - Page 44

2MY/2MZ
1-3-4
Developer U135 Checking toner motor operation
-
U136 Setting toner near end detection
0/0
U139 Displaying the temperature and humidity outside the
machine
-
U140 Setting developer bias
480/480/450/450
50/50/50/50
380/380/350/350
180/180/150/150
150/150/150/150
180/180/150/150
36/36/36/36
36/36/36/36
36/36/36/36
37/37/37/37
33/33/33/33
33/33/33/33
1500/1500/1500/1500
1150/1150/1150/1150
1150/1150/1150/1150
0/0/0/0
0/0/0/0
U147 Setting for toner applying operation
0/60
U150 Checking sensors for toner
-
U157 Checking the developing drive time
0/0/0/0
Fuser U161 Setting the fuser control temperature
210/240/
190/95/85/
110/135/
140/140/
115/135/
240/85/40/
200/85
210/240/
190/100/90/
115/140/
145/145/
120/140/
240/90/45/
200/90
U167 Displaying fuser heater temperature
0
U168 Confirmation/setting the fuser drive time
0/0
U169 Confirmation/setting the fuser drive time
-
U199 Displaying fuser heater temperature
-
Operation
panel and
support
equipment
U201 Initializing the touch panel
-
U203 Checking DP operation
-
U207 Checking the operation panel keys
-
U222 Setting the IC card type
Other
U243 Checking the operation of the DP motors
-
U244 Checking the DP switches
-
Section
Item
No.
Content of maintenance item
Initial setting
20ppm 25ppm