8
Using the Scan Functions
8-22
8.4 Checking the Transmission Settings
You can check the transmission settings by pressing the [Mode Check]
key on this machine’s control panel.
Touch [Change] beside “File Name” to change the name of the
transmission file. Enter the file name (up to 21 characters) and then touch
[Enter].
When using Scan to E-mail or Scan to Internet FAX, three tabs are
displayed, as shown below.
On the Send screen, you can check the file name and destination. Touch
[Detail] to check the e-mail address of the destination. For Internet FAX,
touch [Set], and then select a Reply-to address from the one-touch keys.
On the Subject/From screen, you can check the subject of the e-mail and
the sender’s address (From address).
Touch [Change] beside “Subject” to change the subject of the e-mail.
Enter the subject (up to 64 characters) and then touch [Enter].
On the Message screen, you can check the contents of the e-mail.
To Next Page
Loading...
