Using the Scan Functions
8
8-65
8.11.1 Flow of Scan Operation
Procedure
1 Using Printer Management Utility, specify the e-mail settings, and
enter the subject and text of the e-mail.
☞ “Setting the E-mail Transmission” on page 8-66 and “Setting the E-
mail Subject and Text” on page 8-69
2 Using Printer Management Utility, perform one-touch key registration
or temporary key registration.
(You can also enter the e-mail address directly from this machine’s
control panel in step 3.)
☞ “Registering Destinations in Advance” on page 8-25
3 Using this machine’s control panel, specify the destination of the
scanned data.
☞ “Setting the Destination” on page 8-70
4 Using this machine’s control panel, set the scan mode and document
designation.
☞ “Scan Mode Screen” on page 8-14 and “Original Setting Screen” on
page 8-16
5 Set the document, and then press the [Start] key on this machine’s
control panel.
The document is scanned. The scanned data is sent using Internet
fax.
✎
Memo
If the e-mail settings, the setting of the subject and text of the e-mail,
and the registration of the destination are already done, perform steps
3 through 5.
To Next Page
Loading...
