Kyocera KM-4230

10
Using the Box Functions
10-14
10.9 Performing Forward to FTP Server Operations
The image data in the box on the hard disk of this machine is forwarded
to a specified folder on the FTP server.
✎
Note
To perform Forward to FTP Server operations, a network environment
with an FTP server is required.
10.9.1 Flow of Forwarding Operation
Procedure
1 Using Printer Management Utility, register FTP servers (up to five).
☞ “Registering FTP Servers” on page 8-48
2 If “Use Proxy” was set to “Yes” in the FTP Server Registration page,
set the proxy server.
☞ “Setting the Proxy Server” on page 8-51
3 Using Printer Management Utility, perform one-touch key registration
or temporary key registration.
☞ “Registering Destinations in Advance” on page 8-25
4 Using this machine’s control panel, select the files to be forwarded.
☞ “Selecting the File to be Forwarded” on page 10-4
5 Using this machine’s control panel, specify the forward destination of
the image data.
☞ “Specifying the Forward Destination” on page 10-5
6 On this machine’s control panel, press the [Start] key.
The image data in the box is forwarded to the FTP server.
If a URL notification destination is specified, information indicating the
storage location of the image data is sent by e-mail.