Kyocera KM-4230

13
Using the BOX Utility
13-4
13.5 Registering the Copier
To retrieve image data on the copier hard disk, the copier must be
registered in the utility program. Up to 10 copiers can be registered.
Registration procedure
1 Click the [Start] button, and then click “Programs” – “BOX Utility” –
“BOX Utility” – “BOX Utility” to start up the BOX Utility.
2 On the “Setup” menu, click “Register MFP Controller”.
The setup dialog box below appears.
3 Click the [New Registration] button.
4 Enter the registration name in the Name box (up to 16 characters) and
the IP address of the copier in the Host box.
✎
Memo
The following symbols cannot be used in the box name.
\ / : * ? " < > |
For the procedure to set the IP address of this machine, refer to
“Setting the IP Address for This Machine” on page 6-2.
5 Press the computer keyboard’s [Enter] key and click the [OK] button.
The registration is saved.