Using the Scan Functions
8
8-13
8.3 Settings for Scanning
When sending image data using a scan function, the following parameters
can be entered from this machine’s control panel.
Displaying the setup screen
1 On this machine’s control panel, press the [Scan] key.
2 If network user authentication is enabled, a login screen appears. In
this case, enter the network user name and password, and then touch
[Login].
✎
Memo
For details on specifying settings for network user authentication,
refer to “User Authentication” on page 12-71.
3 Touch the button for the desired screen ([Scan Mode], [Address],
[Original Setting], and [MISC.]).
To Next Page
Loading...
