Kyocera KM-4230

Using the Scan Functions
8
8-53
8.9 Performing Scan to PC Operations
The Scan to PC operation is used to send the image data scanned on this
machine directly to a computer using FTP.
✎
Note
An FTP server application must be installed on the computer in
advance.
8.9.1 Flow of Scan Operation
Procedure
1 Using Printer Management Utility, perform one-touch key registration
or temporary key registration.
☞ “Registering Destinations in Advance” on page 8-25
2 Set the FTP application.
☞ “Setting the FTP Application” on page 8-54
3 Start up the FTP application on the computer.
4 Using this machine’s control panel, specify the destination of the
scanned data.
☞ “Setting the Destination” on page 8-54
5 Using this machine’s control panel, set the scan mode and document
designation.
☞ “Scan Mode Screen” on page 8-14 and “Original Setting Screen” on
page 8-16
6 Set the document, and then press the [Start] key on this machine’s
control panel.
The document is scanned. The scanned data is sent to an application
that receives the data using FTP.
7 Check the scanned data on the recipient computer.
✎
Memo
If the registration of the destination and the FTP application
configuration are already done, perform steps 3 through 7.
The transmission destination to the computer is the root folder
specified by the application. The destination cannot be specified from
this machine.