3
Connecting to a Computer
3-2
Connection procedure
1 Make sure this machine is turned off.
2 Connect one end of the 10Base-T/100Base-TX cable to the 10Base-
T/100Base-TX port on this machine, and connect the other end of the
cable to the network hub.
This machine is now connected to the network.
3 When this machine is turned on, LED1 will light up.
❍ LED1: LINK Lights up if this machine is properly connected
to the network.
❍ LED2: ACT Blinks depending on the data reception status.
LED 1
LED 2
To Next Page
Loading...
