12
Using Printer Management Utility
12-68
Procedure
1 Specify the desired settings, and then click the [Create] button.
2 When the message “The Certificate has been created.” appears, click
the [OK] button.
If you have created a new certificate, log out once from Administrator
mode.
If you have changed settings, the specified SSL/TLS information is
displayed.
✎
Note
If a given time elapses after creating a self-signed certificate (while
“The certificate has been created.” is displayed), the message
“Connection uses SSL/TLS.” appears at the top section. If this
message appears, do not click the [OK] button under the message. If
you do, you will be logged out from Administrator mode, but this
machine’s control panel will be locked. You will not be able to copy or
print until the timeout occurs.
Page showing the settings
When specifying SSL/TLS settings, the following page appears.
Procedure
➜ To change or delete the certificate or change the encryption strength,
click the [SSL/TLS Setting] button.
To Next Page
Loading...
