Network Printing in a Windows Environment
6
6-15
6 In Administrator mode of Printer Management Utility, from the
“Network” tab, select Common Setting – NetWare Configuration,
and then specify the following settings for the printer controller.
❍ Enable NetWare: Select “Enable”.
❍ Frame Type: Select “Auto Detect”. (Select the frame type
according to the network environment.)
❍ Bindery/NDS: Select “Bindery”.
❍ Print Server Name:Print server name created in step 4
❍ Print Server Password:
Specify only when setting from the NetWare
Server.
❍ Preferred File Server:
Name of the file server that connects to
PServer
❍ Print Queue Scan Rate:
1 (Change as necessary.)
❍ Mode: PServer
7 Restart this machine (turn it off, then on again).
8 Use the NetWare Server console to load MONITOR.NLM.
9 Select the connection information and, in the active connection
column, check that the created PServer is connected.
To Next Page
Loading...
