Printing Functions
OPERATION GUIDE 5-5
5
Printing Quick Copy/Proof-and-Hold
If you set quick copy with the printer driver when printing a document, the data is printed and stored in the hard
disk. When printing is required, you can print a required number of copies from the operation panel.
If you set proof-and-hold with the printer driver and set the required number of copies to execute printing, only
one set is output and the document data is stored in the hard disk. To print the remaining number of copies,
execute printing from the operation panel. At this time, you can change the number of copies.
For the method of setting with the printer driver, refer to the KX Printer Driver Operation Guide.
Use the procedure below to center then image when sending a scanned image.
1 Display the e-MPS screen. (See How to Display the
e-MPS Screen on page 5-4.)
2 Press U or V to select Quick Copy, and then
press the Enter key.
3 Press U or V to select the user name, and then
press the Enter key.
The user name is the name that has been set with
the printer driver.
4 Press U or V to select the desired job name, and
then press the Enter key.
The job name is the name that has been set with
the printer driver.
5 Enter the number of copies using the numeric key,
and then press the Enter key.
Printing starts.
Deleting Quick Copy/Proof-and-Hold
Jobs stored with the quick copy/proof-and-hold are deleted automatically when the power of this machine is
turned off. Each job, however, can be deleted manually as shown below.
1 Select the job to delete referring to steps 1 to 4 of
Printing Quick Copy/Proof-and-Hold.
2 Press U or V to select Delete, and then press the
Enter key.
To Next Page
Loading...
