Preparation before Use
OPERATION GUIDE 2-15
2
Loading Paper in the Cassettes
Standard paper, recycled paper, and colored paper can be loaded into the cassette. Up to 300 sheets of
standard paper (80 g/m
2
) or 100 sheets of thick paper (90 to 105 g/m
2
) can be set.
The following paper sizes are supported: A3, B4, A4, A4R, B5, B5R, A5R, Folio, 11 × 17" (Ledger), 8
1/2 ×14"
(Legal), 11 × 8
1/2", 8 1/2 × 11" (Letter), 5 1/2 ×81/2" (Statement), 8 1/2 × 13" (Oficio II), 8K, and 16K.
IMPORTANT:
• You should not use inkjet printer paper or any paper with a special surface coating. (Such papers may
cause paper jams or other faults.)
• Do not load thick paper that is heavier than 105 g/m
2
in the cassettes. Use the MP tray for paper that is
heavier than 105 g/m
2
.
1 Pull the cassette out toward you until it stops.
NOTE: Do not pull out more than one cassette at a
time.
2 Push down on the cassette base plate and secure
it.
3 Holding the paper width adjusting tab, move the
paper width guides to fit the paper.
IMPORTANT: Make sure that the width guides are flush
against the paper. If there is space between the guides
and the paper, set the width guides again.
NOTE: The paper sizes are impressed in the cassette.
To Next Page
Loading...
