Preparation before Use
2-16 OPERATION GUIDE
4 Using the paper length guide, move the plate to fit
the paper.
IMPORTANT:
• Make sure that the length guide is flush against the
paper. If there is space between the guide and the
paper, set the length guide again.
• When setting 11 x 17" (Ledger) paper, move the
paper length guide to the right end and push it down
as shown in the illustration.
NOTE: The paper sizes are impressed in the cassette.
5 Set the paper straight from the upper part.
IMPORTANT:
• Be careful not to bend or crease the paper when
inserting it into the cassette. Creases in the paper
may lead to paper jams.
• The maximum paper limit indicator A is provided on
a paper width guide. Make sure that the paper
loaded is below the maximum paper limit indicator.
• When loading paper into the cassette, set it with the
side which faced the top of its packaging facing up.
• Be sure to adjust the width and length guides to the
paper size before loading the paper. Failure to do so
may result in paper skewing or jamming.
To Next Page
Loading...
