Kyocera TASKalfa 181

Printing Functions
OPERATION GUIDE 5-43
5
1 Display the Paper Handling screen. (See How to
Display the Paper Handling Screen on page 5-41.)
2 Press U or V to select Duplex Mode, and then
press the Enter key.
3 Press U or V to select Short edge bind or
Long edge bind, and then press the Enter key.
4 Press the Reset key.
The message display returns to the printer basic
screen.
Output Destination
Set the paper output destination.
NOTE: This item is displayed only if the optional finisher or job separator is installed.
1 Display the Paper Handling screen. (See How to
Display the Paper Handling Screen on page 5-41.)
2 Press U or V to select Stack Select [Stack
Slect], and then press the Enter key.
3 Press U or V to select the desired paper output
destination, and then press the Enter key.
4 Press the Reset key.
The message display returns to the printer basic
screen.
Paper Handling
MP Tray Mode
Feed Select
Duplex Mode
Duplex Mode
Back
None
Short Edge Bind
Setting Output destination
Top tray Output tray of main body
Finisher Optional finisher
Job Separator Optional job separator
MP Tray Mode
Paper Handling
Feed Select
Stack Select
Back
Top Tray
Select Output Tray
Finisher