Kyocera TASKalfa 181 - Resource Protect Mode

Printing Functions
OPERATION GUIDE 5-47
5
3 Press U or V to select OK, and then press the
Enter key.
The printer functions are reset.
Resource Protect Mode
The resource protect mode protects the resource data such as downloaded fonts and macros and memorizes
the PCL resources even if the emulation mode is switched. If you select Permanent, temporary resources are
not protected. If you select Perm/Temp, however, temporary resources are also protected.
1 Display the Others screen. (See How to Display the
Others Screen on page 5-45.)
2 Press U or V to select Resource Prot, and then
press the Enter key.
3 Press U or V to select Off, Permanent, or
Perm/Temp, and then press the Enter key.
4 Press the Reset key.
The message display returns to the printer basic
screen.
Printer Reset
Back
OK
Resource Prot .
Others
Print HEX -DUMP
Printer Reset
Back
Off
Resource Prot .
Permanent