Copying Functions
4-30 OPERATION GUIDE
Interrupt Mode
This function allows you to pause the current jobs in progress when you need to make copies immediately.
When interruption copy ends, the machine resumes the paused print jobs.
The following modes are available for the interrupt function.
During a Copy Job
The procedure for using Interrupt Mode during a copy job is explained below.
1 Press the Interrupt key.
Interrupt mode OK [Interrupt mode] is
displayed.
2 Store the originals for the current copying.
3 Place the originals for interrupt copying and
perform copying.
4 After the interrupt copying is complete, press the
Interrupt key. The settings for the interrupted job
are restored.
5 Replace the original with the originals that have
been stored. Press the Start key to resume
copying.
Mode Description
Interrupt copy This mode can be used to stop copying and to make a
copy of a different original at different settings. After the
interrupt copy has been produced, the interrupted copying
can be resumed at the same settings in effect prior to the
interruption.
This mode can also be used to stop output of a job and to
make a copy of another job. After the interrupt copy has
been produced, the interrupted job is resumed. Priority
output This mode can be used to interrupt output of a job.
Priority output This mode can be used to interrupt output of a job and to
output print data or received fax data with priority. After
priority output is complete, the interrupted job is resumed.
NOTE: To use the fax functions, the optional fax kit must
be installed.
To Next Page
Loading...
