Kyocera TASKalfa 181 - Page 109

Printing Functions
OPERATION GUIDE 5-9
5
Capacity for Storage of Temporary Code Jobs
Set the total capacity (upper limit) for storage of temporary code jobs in the hard disk. The actual maximum size,
however, is the size of available hard disk space.
1 Display the e-MPS screen. (See How to Display the
e-MPS Screen on page 5-4.)
2 Press U or V to select e-MPS Configuration,
and then press the Enter key.
3 Press U or V to select Temp Code Job Size
[Temp. code Job size], and then press the
Enter key.
4 Press Y or Z to enter the capacity for storage of
temporary code jobs.
You can set the capacity to 0 to 9999 MB.
5 Press the Enter key.
Total Capacity for Storage of Permanent Code Jobs
Set the total capacity (upper limit) for storage of permanent code jobs in the hard disk. The actual maximum size,
however, is the size of available hard disk space.
1 Display the e-MPS screen. (See How to Display the
e-MPS Screen on page 5-4.)
2 Press U or V to select e-MPS Configuration,
and then press the Enter key.
3 Press U or V to select Perm Code Job Size
[Perm. code Job size], and then press the
Enter key.
4 Press Y or Z to enter the total capacity for storage
of permanent code jobs.
You can set the capacity to 0 to 9999 MB.
5 Press the Enter key.
List of VMB
List of Code JOB
e-MPS
e-MPS Configuration
Back
Back
e-MPS Configuration
Temp Code Job Size
Temporary Code Job Size
1550 Mbyte
List of VMB
List of Code JOB
e-MPS
e-MPS Configuration
e-MPS Configuration
Temp Code Job Size
Perm Code Job Size
Quick Copy
Permanent Code Job Size
1550 Mbyte