Kyocera TASKalfa 181 - Page 155

System Menu
OPERATION GUIDE 6-3
6
3 Enter the four-digit management code using the
numeric keys.
The management code at the factory default
setting is 1800 for the 18 ppm model and 2200 for
the 22 ppm model.
NOTE: The four-digit management code can be
changed. (See Administrator Management Code
Change on page 6-24.)
4 If the management code is accepted, the Copy
Default screen is displayed.
Next, perform the setting referring to the following
description of each setting item.
NOTE: The * (asterisk) at an item on each setting
screen indicates the current setting.
Density Mode
Set the Default exposure mode: auto or manual.
1 Display the Copy Default screen. (See How to
Display the Copy Default Screen on page 6-2.)
2 Press U or V to select Exposure Mode, and then
press the Enter key.
3 Press U or V to select Auto or Manual, and then
press the Enter key.
4 Press the Reset key.
The message display returns to the copier basic
screen.
Original Image Quality
Set the default original image quality mode.
1 Display the Copy Default screen. (See How to
Display the Copy Default Screen on page 6-2.)
Enter Pin Code using # key.
End
Density Mode
Copy Default:
Original Image
Manual
Txt+Phto
:
:
End
Density Mode
Copy Default:
Original Image
Manual
Txt+Phto
:
:
Density Mode :
Auto
Manual
*