Kyocera TASKalfa 181 - Page 177

System Menu
OPERATION GUIDE 6-25
6
4 Press the Reset key.
The message display returns to the copier basic
screen.
Auto Sleep
The machine enters automatically the sleep mode when the preset time elapses without any operation if this
setting is turned On.
NOTE: This setting is displayed only on the inch specification machine.
You can disable the auto sleep function if this function causes inconvenience. It is recommended, however, to
set a longer time that elapses before the auto sleep function is activated, before disabling this function.
1 Display the Machine Default screen. (See How to
Display the Machine Default Screen on page 6-13.)
2 Press U or V to select Auto Sleep, and then
press the Enter key.
3 Press U or V to select Off or On, and then press
the Enter key.
4 Press the Reset key.
The message display returns to the copier basic
screen.
Auto Clear
You can set the auto clear function (refer to Chapter 1 in Basic Operation Guide, Auto Clear Function) that will
be activated when the preset time elapses after copying is complete.
1 Display the Machine Default screen. (See How to
Display the Machine Default Screen on page 6-13.)
2 Press U or V to select Auto Clear, and then
press the Enter key.
3 Press U or V to select Off or On, and then press
the Enter key.
On:
:
Auto Sleep
Machine Default :
PIN # Change
Display Contrast
Auto Sleep :
Off
On
*
On:
On:Auto Clear
Auto Sleep
Machine Default :
PIN # Change
Auto Clear :
Off
On
*