Troubleshooting
9-6 OPERATION GUIDE
Clean the slit
glass for
original fed from
DP.
[Clean the slit
glass
original fed from
DP.]
The slit glass is dirty. Clean the slit glass because black
lines may be copied when the
optional document processor is used.
—
Close ## cover. The indicated cover is
open.
Close all the covers securely. —
Exceed copy limit.
Unable to copy
The number of copies
made with your
management code has
reached the limit that was
set in the department
management mode and
copying is no longer
possible with that code.
Use the department management
mode to clear the copy count.
7-11
Format error Memory
card
The memory card inserted
in the machine must be
formatted.
Format the memory card. —
Interface occupied The selected interface is
currently being used.
Wait for a while and retry. —
Insert same memory
card
When the machine has
tried to read data from the
memory card, it cannot
recognize the memory
card.
Insert the memory card again.
NOTE: When inserting the memory
card, turn the main power switch off.
—
MemoryCard err
Press GO
An error has occurred in
writing to or reading from
the memory card.
Press the Print key, select GO, and
then press the Enter key. The error
will be cleared,
—
Error Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
