Copying Functions
OPERATION GUIDE 4-21
4
3 Press the Combine key.
4 Press U or V to select the desired combine
copying mode, and then press the Enter key.
5 Press U or V to select the type of the lines to
indicate page boundaries, and then press the
Enter key.
6 Press the Start key to start scanning.
If the originals have been set in the optional
document processor, copying starts automatically.
If the original has been set on the platen, a
message prompting replacement of the original is
displayed. In this case, proceed to the next step.
7 Replace the original, and then press the Start key.
Scanning of the original is performed.
8 After scanning all originals, press the Enter key to
start copying.
To Next Page
Loading...
