Copying Functions
4-26 OPERATION GUIDE
Book to One-sided
Produces a 1-sided copy of a 2-sided or open book
original.
Book to Two-sided
Produces two-sided copies from an open book original
with facing pages.
NOTE: The original sizes that can be used are A3, B4,
A4R, B5R, A5R, 11 x 17" (Ledger), 8
1/2 x 11" (Letter),
and 8K. The paper sizes are limited to 11 x 8
1/2" and
16K in the inch specifications and A4, B5, and 16K in
the metric specifications. The paper size can be
changed and the zoom ratio adjusted to fit the size of
the paper.
The procedure for using two-sided/duplex copying is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press the Duplex key.
4 Press U or V to select the desired duplex copy
mode, and then press the Enter key.
If you have selected 1 sided->2 sided [1-sided->2-
sided], proceed to the next step.
If you have selected 2 sided->2 sided [2-sided->2-
sided], or Book->2-sided, proceed to step 7.
5 Press U or V to select the desired finished stitch
side, and then press the Enter key.
6 Press the Start key to start scanning.
If the originals have been set in the optional
document processor, copying starts automatically.
If the original has been set on the platen, a
message prompting replacement of the original is
displayed. In this case, proceed to the next step.
7 Replace the original, and then press the Start key.
To Next Page
Loading...
