Kyocera TASKalfa 650c - Page 242

7 COMMAND CENTER ADMINISTRATOR MODE
240 Registering From COMMAND CENTER
 If the Forced Encryption setting is enabled, you cannot clear the [Encryption] check box. For the Forced
Encryption function, refer to the MFP Management Guide.
 The user password is set “12345” at our factory. Ask the administrator to reset the master password.
 Passwords must be from 1 to 32 one-byte alphanumeric characters.
 The user password must differ from the master password.
 These passwords can be re-entered only by an authorized user. Users cannot change the settings of the
[Encryption Level] box and the [Authority] box noted below if they are not authorized to change the master
password. Ask the administrator for resetting these passwords.
 For the details of the encryption setting, refer to the MFP Management Guide.
Encryption Level
Select the desired encryption level.
- 40-bit RC4 — Select this to set an encryption level to the one compatible with Acrobat 3.0, PDF V1.1.
- 128-bit RC4 — Select this to set an encryption level to the one compatible with Acrobat 5.0, PDF V1.4.
- 128-bit AES — Select this to set an encryption level to the one compatible with Acrobat 7.0, PDF V1.6.
Authority
Select the desired types of authority for Encrypt PDF.
- Printing — Select this to authorize users to print documents.
- Change of Documents — Select this to authorize users to change documents.
- Content Copying or Extraction — Select this to authorize users to copy and extract the contents of documents.
- Content Extraction for accessibility — Select this to enable the accessibility feature.
7) File Name
The file name will be “(From Name)-NNN”. The file name cannot be changed.
8) Fragment Message Size
Select the size of the message fragmentation.