8-2 Test and Adjustment
D-I012.1109EN
innovators in agriculture
4. Select Beepfreq route and push [ ].
5. Select the route you want to modify and push [
].
6. Push [
] or [ ] to modify the number of beeps per second.
Note:
The standard value 0.5 equals one beep per two seconds.
7. Push [ESC] to confirm and go one level up.
8.2.4 Modify the Beep Length
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. In the main menu of the E-Link, select Settings and push [
].
4. Select Beep length.
5. Push [
] or [ ] to modify the length.
Note:
The standard value is 200 mSec.
6. Push [ESC] to confirm and go one level up.
8.2.5 Modify the Feed Push Power
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. In the main menu of the E-Link, select Settings and push [
].
4. Select Feed push power.
5. Push [
] or [ ] to modify the power (page 4-24).
6. Push [ESC] to confirm and go one level up.
8.3 Tests
8.3.1 Analyse the Reliability of a Route
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. Stop all timed actions (page 6-13).
4. In the main menu of the E-Link, select Routes and push [
].
5. Select 'Route analysis' and push [
].
6. Select 'Fail. problty' and push [ ].
To Next Page
Loading...
