Installation 5-17
D-I012.1109EN
innovators in agriculture
3. If the indicator on the E-Link is below the middle position on the
scale, raise the inductive sensor until the indicator is in the middle
of the scale.
4. Tighten the bolts that secure the clamp (1).
5. Install the cover (page 7-2).
6. Push button [ESC] to go up one level.
Figure 35. Adjust the inductive sensor
KEY:
1. Clamp - 2. Clamp - 3. Level X-Y- 4. Level Z - 5. Clamp
5.6.4 Make Different Routes per Distance to the Feed Fence
Preparation
1. Read the requirements for a good route (page 6-5).
2. Remove the feed near the feed fence before you program a route.
Note:
Make different routes each starting and finishing at the charge unit. This
enables you to push the feed to each feed fence at a different time.
3. Plan different routes along the feed fence (fig. 36, page 5-18), each
with a different distance to the fence (for instance 1.80 m (5.9 ft),
1.60 m (5.2 ft), 1.40 m (4.6 ft) and 1.20 m (3.9 ft)).
To Next Page
Loading...
