LELY JUNO 150 - Time Path Setup and Backup Procedures

6-12 Operating Instructions
D-I012.1109EN
innovators in agriculture
6. Do the previous steps if you want to add another feed group
to this feed push action.
Note:
The total length of the feed groups must be equal to the length of the feed
push action.
12. Push [ESC] and push soft button [save].
6.7.8 Define the Push Power for a Feed Group
1. Connect the E-Link Manual Controller.
2. Push [ESC] or [
] to wake-up the E-Link.
Note:
The E-Link Manual Controller automatically goes into sleep mode when it is
not used for 10 minutes.
3. Stop all timed actions (page 6-13).
4. In the main menu of the E-Link, select 'Routes' and push [
].
5. Select 'push power' and push [
].
6. Select the applicable feed group and push [
].
7. Select the applicable push power and push [
].
8. Push button [ESC].
6.7.9 Set a Time Path
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. Stop all timed actions (page 6-13).
4. In the main menu of the E-Link, select
Routes and push [ ].
5. Select time path and push [
].
Refer to the time path description.
Note:
The JUNO 150 must not drive more than 40% of the total time in a time path.
It must spend minimum 60% of the total time charging at the charging
station.
6. Push soft button [New].
7. Push soft button [>].
8. Push [
] to select the start time (hour) and push soft button [>].
9. Push [
] to select the start time (minutes) and push soft button
[>].
10. Push [
] to select the route and push soft button [>].