Maintenance 7-1
D-I012.1109EN
innovators in agriculture
7. MAINTENANCE
7.1 Introduction
This chapter contains the preventive maintenance schedule and the
applicable preventive maintenance procedures for the JUNO 150. It also
contains some basic corrective maintenance procedures.
7.2 Preventive Maintenance Schedule
The following table shows the preventive maintenance schedule for the
JUNO 150. Preventive maintenance must obey local regulations, if
applicable.
Note:
The frequencies of the tasks shown in the table are the minimum frequencies
recommended.
Frequencies Maintenance Tasks
Operating
Months
Operating
Years
Note
Clean the charging strips (page 7-4) 1
Clean the charging electrodes on the charge
unit (page 7-5)
1
Check the drive chains and tighten if necessary
(page 7-6)
1
Tighten new chains
again after 2 days
Check the battery voltage (page 8-3) 1
Adjust the skirt height (page 5-14) 4
If the feed alley is not
clean enough
Replace the rubber skirt (page 7-5)
3 - 4 Replace if broken or
worn out
To Next Page
Loading...
