5-14 Installation
D-I012.1109EN
innovators in agriculture
5.6 Setup the JUNO 150
5.6.1 Adjust the Skirt Height
Preparation
1. Manually drive the JUNO 150 to a clean and quiet location (page
6-4).
2. Remove the cover (page 7-2).
3. Switch OFF the JUNO 150 (page 7-3, page 6-3).
4. Break the power circuit (page 7-2).
Adjust
1. Loosen the knob (3)
2. Turn the handle (1) until the skirt on the side of the feed fence (2)
and on the front side (4) reaches the floor.
3. Fasten the knob.
4. Make sure the height of the lower charging strip is 76.5 cm (30.1
in.).
Close-up
1. Close the power circuit (page 7-2).
2. Put the JUNO 150 in operation (page 7-3, page 6-3).
3. Install the cover (page 7-2).
4. Get the E-Link manual controller (page 6-2).
5. Manually drive the JUNO 150 to the charging station (page 6-4).
6. Make sure the charging strips of the JUNO 150 make good contact
with the electrodes.
7. Start the timed actions (page 6-13).
To Next Page
Loading...
