LELY JUNO 150 - Modify the Feed Push Power; Set the Height of the Inductive Sensor

Installation 5-15
D-I012.1109EN
innovators in agriculture
Figure 34. Set the skirt height (without cover)
KEY:
1. Handle - 2. Feed fence side of the skirt - 3. Knob - 4. Front side of the skirt
5.6.2 Modify the Feed Push Power
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. In the main menu of the E-Link, select Settings and push [
].
4. Select 'Strip width'.
5. Push [
] or [ ] to select the strip width (page 4-24).
6. Push button [ESC] to go up one level.
5.6.3 Set the Height of the Inductive Sensor
Preparation
1. Make sure the inductive sensor is level (page 5-15).
2. Get the E-Link Manual Controller (page 6-2).
3. Push [ESC] or [
] to wake up the E-Link.