9-2 Troubleshooting
D-I012.1109EN
innovators in agriculture
9.2.2 Alarm List
The table below gives the alarm numbers and any actions to be taken:
Alarm
code
Alarm message Description on the E-link
display
Recovery procedure
1 EMPTY_BATTERY "Battery power too low to
start route, charge first! "
1. Clean the charging strips and the
charging electrodes (page 7-4).
2. Manually drive the JUNO 150 to the
charging station (page 6-4).
3. Make sure the battery is charging
(page 8-3).
4. If the problem remains, call your local
Lely service provider.
3 JUN_OFF_RANGE Juno lost -> searching reset
point (strip)
Test the inductive sensors
1. Make sure the inductive sensors are
installed 1-2 cm above the floor.
2. Adjust the height of the inductive
sensors if necessary (page 5-15).
3. Make sure the inductive sensors are
installed level.
4. Level the inductive sensors if
necessary (page 5-15).
5. If the problem remains, call your local
Lely service provider.
4 TURN BLOCK Juno can not make the turn!
1. Make sure there are no obstacles.
2. Make sure the rotating skirt is free to
rotate, adjust if necessary (page 5-14).
3. Make sure the rubber skirt is not
worn, replace if necessary (page 7-5).
4. Make sure the chains and chain
wheels are complete and connected
properly (page 7-6).
5. Make sure the motors are functioning
properly.
6. Analyse the route and make a more
reliable route if necessary (page 8-2).
7. If the problem remains, call your local
Lely service provider.
5 NO TIME No active time!
1. Set the time path and try again (page
6-12).
6 BLOCKAGE_JUN Juno blocked!!
1. Make sure there are no obstacles.
2. Try to run the route again.
3. If the JUNO 150 is blocked by the
forage, make routes with smaller
intervals.
4. If the JUNO 150 is blocked at a
different place, calibrate the
gyroscope (page 9-14).
To Next Page
Loading...
