LELY JUNO 150 - Page 107

Troubleshooting 9-3
D-I012.1109EN
innovators in agriculture
Alarm
code
Alarm message Description on the E-link
display
Recovery procedure
7 JUNO_LOST Juno deviates from correct
directn!
- obstacle
- gyro drifting
- bend in route
1. Make sure there are no obstacles.
2. Calibrate the gyroscope (page 9-14).
3. Test the ultrasonic sensor (page 8-4).
4. Start the timed actions (page 6-13).
5. If the problem remains:
1. Analyse the route and make a
more reliable route if necessary
(page 8-2).
6. If the problem remains, call your local
Lely service provider.
8 TURN ERROR Juno turns more than 360
deg!
- Check gyroscope
- Calibrate via menu Settings
1. Calibrate the gyroscope (page 9-14).
2. If the problem remains, call your local
Lely service provider.
9 LOADING No charging current! Check
charge strips for dirt
1. Clean the charging strips and the
charging electrodes (page 7-4).
2. Manually drive the JUNO 150 to the
charging station (page 6-4).
3. Make sure the battery is charging
(page 8-3).
4. If the problem remains, call your local
Lely service provider.
10 STARTUP Alarm appears with every startup of the
JUNO 150. For information only.
11 ROUTE-MEMORY Route memory is full. First
delete one route!!
1. Delete a route prior to programming
a new one (page 6-10).
12 NO_ULTRASIGN No ultrasound signal:
- dirt on sensor
- no object
1. Clean the ultrasonic sensor.
2. If the problem remains, call your local
Lely service provider.
13 BENDSKIDDING Juno skid in the turn!
1. Make sure the floor is not slippery.
2. Make sure the wheels are not worn
out. If so, call your local service
provider.
3. Make sure the rubber skirt is not
worn out, replace if necessary (page
7-5).
4. Manually run the route again (page
6-14).
5. If the problem remains, call your local
Lely service provider.
14 EXTRA CHARGE1 Voltage is too low, the JUNO 150
recharges for an extra hour. For
information only.
15 EXTRA CHARGE2 More than 20Ah used. For information
only.
16 EXTRA READY1 Recharging is complete. For information
only.