Installation 5-9
D-I012.1109EN
innovators in agriculture
2. Connect the ground wire (1, fig. 29, page 5-9) to the electrode
assembly (2) with the M6 bolt, shake-proof washer (A6.4) and nut.
3. Install the self-adhesive cable ties (3) on the mounting plate, at
least 35 mm (1.4 in.) from the left edge of the plates, to prevent the
cover from damaging the wire.
4. Feed the ground wire through the self-adhesive cable ties.
5. Secure the earth wire on the frame with cable ties.
6. Connect the end of the ground wire to the ground wire of the
grounding pin.
Figure 29. Install the earthing
5.4.6 Install the Cover
1. Push the battery charger to the back.
2. Make sure the upper side of the cover is approximately 5 cm (1.9 in)
above the upper side of the mounting plate.
3. Push the cover on the mounting plate.
4. Make sure the two hooks (fig. 30, page 5-10) (1, 4) on the mounting
plate are exactly under the corresponding holes (2) and (3) inside
the cover.
To Next Page
Loading...
