LELY JUNO 150 - 1. Introduction to the JUNO 150 Feed Pusher

Introduction 1-1
D-I012.1109EN
innovators in agriculture
1. INTRODUCTION
The JUNO 150 Feed Pusher is a battery-driven vehicle that pushes the
forage towards the feed fence of the barn. This gives the cows better
access to more fresh food through the day. The rotating lower part of
the side of the JUNO 150 pushes the forage against the feed fence while
the vehicle drives along the feeding alley.
The dairy farmer (operator) uses the E-link remote control to program
the route to be followed by the JUNO 150. Routes are flexible so the
dairy farmer has the option to do more feed pushing in some areas of
the barn during certain hours of the day.
The information in this manual is for operators and technicians.
• The operator uses the information to program and operate the JUNO
150. They also use the information to do maintenance.
• The technician uses the information to install and set up the JUNO
150, to program the initial route and to instruct the farmer.
Both the operator and the technician should refer to the description and
the operation section for background information. They must also read
and understand the safety instructions in the safety section.
The operator must read the operating instructions for daily operation
and for the setup of routes and time paths. He must also read the test
and adjustment section for the setup and testing of the JUNO 150 and
the routes.
The operator must also read the maintenance and troubleshooting
sections for preventive maintenance and basic corrective maintenance
instructions.
The technician must read the installation section for installation
instructions and the operating instructions for the setup of routes and
time paths.
The technician must also read the test and adjustment section for the
setup and for testing of the JUNO 150 and the routes.