EasyManua.ls Logo

LELY JUNO 150 - Charging Station Location and Installation

LELY JUNO 150
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation 5-3
D-I012.1109EN
innovators in agriculture
5.2.4 Plan the Location of the Charging Station
The correct location of the charging station depends on the operational
management of the farm. Analyze the operational requirements of the
farm before you install the charging station.
Plan the routes through the barn before you install the charging station.
Note:
Please contact your Lely service provider for help with specific requirements.
Recommendations for the installation of the charging station
If possible, find a central location in the barn to avoid redundant
driving.
Install the floor column (if supplied) on a clean and even floor
surface.
Make sure the required power supply is available near the charging
station.
Make sure the required earth connection is available near the
charging station.
The location of the charging station is important. To allow the JUNO
150 to park and depart correctly, there must be 3 m (9.8 ft) clear
space on the left side of the charging station and 1.5 m (4.9 ft) clear
space on the right side (fig. 24, page 5-3).
Make sure there is minimum cow interference with the charging
station.
Note:
The JUNO 150 approaches the charging station from the left side.
Figure 24. Necessary room for installation of the charge unit
5.3 Install the Safety Decal 'Danger, Area with Unmanned
Autonomous Vehicle
1. Install the decal 'Danger, Area with Unmanned Autonomous
Vehicle' on a highly visible place near the entrance of the barn
(page 2-6).

Table of Contents

Other manuals for LELY JUNO 150

Related product manuals