5-8 Installation
D-I012.1109EN
innovators in agriculture
4. Connect the 12 V cable (6) to the electrode assembly with the two
M6 bolts:
1. Connect the lead of the brown (or red) cable to the (+)
terminal (5).
2. Connect the blue (or black) cable to the (-) terminal.
Note:
Make sure the cable is minimum of 2 cm (0.8 in.) from the side.
5. Connect the cable to the frame with self-adhesive cable ties.
Figure 28. Install the battery charger
5.4.5 Install the Earthing
Parts
• Bolt M6x16
• Nut M6
• Shake-proof washer A6.4
• 3 Self-adhesive cable ties.
Installation
1. Find the ground wire of a nearby secure grounding pin.
Note:
You can also use the grounded part of a cubicle, a feed fence or a barn frame.
To Next Page
Loading...
