LELY JUNO 150 - Troubleshooting Tables for Vehicle and Station

Troubleshooting 9-11
D-I012.1109EN
innovators in agriculture
9.3 Troubleshooting Tables
9.3.1 Troubleshooting Table JUNO 150 Vehicle
Symptom Possible cause Action
JUNO 150 is switched OFF
1. Switch ON the JUNO 150
Start the timed actions (page 6-13)
The route is blocked
1. Remove the blockage
The battery is low
1. Drive the JUNO 150 to the
charging station (page 6-4)
2. Charge for one hour
The fuse is blown
1. Replace the fuse
The power supply is not
connected
1. Connect the power supply
The vehicle does not move
The emergency stop button is
pushed
1. Reset the emergence stop
button (page 6-15)
Start the timed actions (page 6-13)
The emergency stop button is
pushed
1. Reset the emergence stop
button (page 6-15)
Start the timed actions (page 6-13)
The collision detector is activated
1. Make sure the collision
detector has no contact with
any object
The route is blocked
1. Remove the blockage
No route is programmed
1. Program a route (page 6-5)
Time path is not set
1. Set the time path (page 6-12)
The vehicle does not start a
route
1. If the problem remains, call
your local Lely service
provider.
JUNO 150 is switched OFF
1. Switch ON the JUNO 150
The E-Link cable is not connected
1. Connect the E-Link cable
The battery is low
1. Drive the JUNO 150 to the
charging station (page 6-4)
2. Charge for one hour
The fuse is blown
1. Replace the fuse
The power supply is not
connected
1. Connect the power supply
The E-Link does not light up
Other
1. Call your local Lely service
provider.
The E-Link display lights up
but the menu is not
displayed
1. Call your local Lely service
provider.
The chains are not tightened
correctly
1. Tighten the chains (page 7-6)
The JUNO 150 vibrates more
than normal when driving
Other
1. Call your local Lely service
provider.