9-12 Troubleshooting
D-I012.1109EN
innovators in agriculture
Symptom Possible cause Action
The gyroscope is drifting
1. Test the gyroscope
Calibrate the gyroscope (page
9-14)
The ultrasonic sensor does not
function correctly
1. Clean the ultrasonic sensor
Test the ultrasonic sensor (page
8-4)
JUNO 150 swings
Other
1. Call your local Lely service
provider.
The charging strips or electrodes
do not make contact
1. Clean the charging strips and
the charging electrodes (page
7-4).
No power supply
1. Make sure the charging
station is connected to the
power supply.
Springs that hold the electrodes
are loose
1. Call your local Lely service
provider.
JUNO 150 does not stop at
the charging station
Other
1. Call your local Lely service
provider.
JUNO 150 does not follow
the guiding strip
1. Call your local Lely service
provider.
JUNO 150 is 'searching' the
fence when driving
Ultrasound L
1. Call your local Lely service
provider.
The skirt does not rotate
smoothly
The rubber skirt is worn out.
1. Replace the skirt (page 7-5).
The action Ultrasound L is
programmed instead of Feed
push L to push the feed
1. Program a new route (page
6-5)
Pushing intervals between the
programmed routes are too large
1. Program new routes with
smaller intervals (not more
than 25 cm or 9.8 in.)
There was to much feed in front
of the feed fence during
programming the routes
1. Remove the feed and
program a new route (page
6-5).
The skirt of the JUNO 150 does
not rotate smoothly
1. Adjust the skirt height (page
5-14)
JUNO 150 has problems with
pushing the feed to the
fence
Other
1. Call your local Lely service
provider.
The skirt is too high
1. Adjust the skirt height (page
5-14)
The skirt is worn
1. Replace the rubber skirt (page
7-5)
While pushing feed, feed is
coming under the skirt or the
feed alley is not clean
Other
1. Call your local Lely service
provider.
To Next Page
Loading...
