9-14 Troubleshooting
D-I012.1109EN
innovators in agriculture
9.4 Recovery Procedures
9.4.1 Reset the System
1. Open the cover of the PCB-box.
2. Switch the JUNO 150 OFF and then ON (page 7-3, page 6-3).
3. Close the cover of the PCB-box.
9.4.2 Calibrate the Gyroscope
1. Get the E-Link Manual Controller (page 6-2).
2. Push [ESC] or [
] to wake up the E-Link.
3. Stop all timed actions (page 6-13).
4. Select Settings and push [ ].
5. Select Gyroscope.
Note:
Do not move the JUNO 150.
6. Push soft button [Yes] and wait until you hear a beep sound
(approximately 5 minutes).
9.4.3 Charge the JUNO 150
1. Manually drive the JUNO 150 to the charging station (page 6-4).
2. Make sure the JUNO 150 is charging (orange and green LEDs are
ON).
3. Let the JUNO 150 charge for a minimum of one hour.
To Next Page
Loading...
