Step 5. Insert the M.2 WLAN module into the connector and press it down until it clicks into the place.
Note: Make sure the module is firmly seated on the adapter.
Figure 94. M.2 WLAN module installation
Step 6. Route the cables in the clips as shown.
Figure 95. M.2 WLAN module installation
Step 7. Route the cables to the rear of the server, make sure to route the cable respectively into the right
hole as shown. Be careful of the difference between the cable colors.
96
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
