Before you remove the M.2 LTE module, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove a LTE/WLAN Antenna (see
“Remove a LTE/WLAN Antenna” on page 78).
5. Remove the M.2 WLAN/LTE wireless adapter (see
“Remove the M.2 WLAN/LTE wireless adapter” on
page 41
).
To remove the M.2 LTE module, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Remove the M.2 LTE module cables from the cable clip.
Figure 70. M.2 LTE module removal
Step 2. Press the module latch. Rotate the M.2 LTE module up and pull it out from the adapter.
Chapter 3. Hardware replacement procedures 83
To Next Page
Loading...
