Important advice, please read first! 5
12.2.5 Setting and deleting bits (switches) using PoM ā step by step
approach ......................................................................................................65
12.3 Programming on the Programming track ......................................................68
12.3.1 What is a programming track? ......................................................................68
12.3.2 Where to connect the programming track/the decoder? ...............................68
12.3.3 Reading out and changing a locomotive address .........................................69
12.3.4 Reading out and programming a CV ............................................................71
12.3.4.1 Binary (bitwise) displaying and changing of the CV value....................... 72
12.4 Error messages while programming on the programming track ....................74
12.4.1 Display of other connected manual controls .................................................74
13 LH101 setup (device setting) .................................................................................75
13.1 Setting the speed step mode ........................................................................75
13.2 Setting the club mode ...................................................................................76
13.2.1 Setting club mode 1 or 2 ...............................................................................77
13.2.2 Setting mode 0 .............................................................................................78
13.3 Counting method for bit representation .........................................................79
13.4 Display brightness ........................................................................................80
13.5 Display contrast ............................................................................................82
13.6 Displaying the version number......................................................................83
13.7 Setting the XpressNet address .....................................................................84
13.8 Reset to ex-factory setting ............................................................................85
13.9 Route interval ...............................................................................................86
14 System setup .........................................................................................................88
14.1 Enabling and disabling the "AUTO" mode ....................................................88
14.1.1 System behaviour with "AUTO" mode enabled .............................................89
14.2 Displaying the system version number .........................................................89
14.3 Deleting locomotive addresses from the command station memory .............90
15 Appendix ................................................................................................................93
15.1 Error messages on the display .....................................................................93
15.2 Routes form ..................................................................................................95
15.3 Trouble shooting ...........................................................................................96
15.4 Tree structure of options of the LH101 .........................................................98
To Next Page
Loading...
