Lenz Digital plus LH101 - Error Messages Relating to Multiple Tractions

56 Operating manual LH101
10.8 Error messages relating to multiple tractions
If you made an error when assembling the multiple traction, you
receive one of the following messages:
Error 24:
The locomotive was not called up before it was added to the MTR or
the locomotive was not given an operating command. You have tried
to add a conventional analogue locomotive (address 0) to a multiple
traction.
Error 25:
One of the locomotives that you wanted to add to the MTR has
already been called up by another manual control.
Error 26:
One of the locomotives that you wanted to add to the MTR is already
part of another MTR.
Error 27:
The speed step of one of the locomotives was not 0 when you
wanted to add it to the multiple traction.
Press the "<=" key to delete the error message.