Lenze 8400 motec User Manual

Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011 L 207
8400 motec | Software Manual
Diagnostics & error management
Error messages of the operating system
9.7.2 Reset of error message
An error message with the response "Fault", "Trouble", or "Warning locked" must be
explicitly reset (acknowledged) after the cause of the error has been eliminated.
 To reset (acknowledge) a pending error message, execute the controller command
C00002/19
="1".
 Tip!
With an online connection to the controller, use the Diagnostics tab of the
»Engineer« and click Error message reset to reset a pending error message.

Lenze 8400 motec Specifications

General

Input Voltage	3-phase 380V to 480V AC
Control Mode	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, short-circuit, overtemperature
Relative Humidity	≤ 95 %, no condensation
Altitude	Up to 1000m above sea level
Storage Temperature	-20°C to 65°C