Lenze 8400 motec User Manual

8400 motec | Software Manual
Motor control (MCTRL)
52 L Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011
5 Motor control (MCTRL)
This chapter provides information on the parameter setting of the controller's internal
motor control.
Topics:
Special features of the 8400 motec
Motor selection/Motor data
Selecting the control mode
Defining current and speed limits
V/f characteristic control (VFCplus)
V/f characteristic control - energy-saving (VFCplusEco)
V/f control (VFCplus + encoder)
Sensorless vector control (SLVC)
Parameterisable additional functions
Encoder/feedback system
Braking operation/braking energy management
Power and energy display
Monitoring

Lenze 8400 motec Specifications

General

Input Voltage	3-phase 380V to 480V AC
Control Mode	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, short-circuit, overtemperature
Relative Humidity	≤ 95 %, no condensation
Altitude	Up to 1000m above sea level
Storage Temperature	-20°C to 65°C