Lenze 8400 motec - Parameters with Subcodes

Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011 L 231
8400 motec | Software Manual
Parameter reference
Structure of the parameter descriptions
11.1.3.4 Parameters with subcodes
Description structure
Parameter setting in the »Engineer«
The »Engineer« parameter list displays each subcode individually. The parameters are set
as described in the previous chapters.
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Setting range
(min. value | unit | max. value)
Subcodes Lenze setting
Cxxxxx/1
Cxxxxx/2
Cxxxxx/3
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1