8400 motec | Software Manual
Commissioning
Commissioning with the »Engineer«
30 L Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011
Diagnostics options
When the »Engineer« is used, trouble during commissioning can be detected and
eliminated conveniently. Proceed as follows:
Check whether error messages appear in the »Engineer«.
– You can find a description of each possible message in the chapter entitled
"Diagnostics & error management
". ( 193)
Check the input terminals for their corresponding setpoints.
–The Terminal assignment tab displays the current input/output signals.
Check the signal flow of the application.
– To do this, open the Application Parameters tab and click on the Signal flow button.
The signal flow which is then shown enables a view of the setpoints being applied
and their processing.
To Next Page
Loading...
