Lenze 8400 motec User Manual

8400 motec | Software Manual
Parameter reference
Parameter list | C00155
256 L Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011
C00155
Parameter | Name:
C00155 | Status word 2
Data type: UNSIGNED_16
Index: 24420
d
= 5F64
h
Bit-coded device status word 2
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Fail Error
Bit 1 M_max Maximum torque
Bit 2 I_max Maximum current
Bit 3 PowerDisabled Power switched off
Bit 4 Ready Controller is ready for operation
Bit 5 ControllerInhibit Controller is inhibited
Bit 6 Trouble Fault
Bit 7 InitState Initialisation
Bit 8 CwCcw CW/CCW rotation
Bit 9 Reserved
Bit 10 SafeTorqueOff Safe torque off
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Quick stop Quick stop is active
Bit 15 MotorIdent Motor parameter identification active
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT

Lenze 8400 motec Specifications

General

Input Voltage	3-phase 380V to 480V AC
Control Mode	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, short-circuit, overtemperature
Relative Humidity	≤ 95 %, no condensation
Altitude	Up to 1000m above sea level
Storage Temperature	-20°C to 65°C