Lenze 8400 motec User Manual

Firmware ≤ 02.00 - DMS 2.1 EN - 03/2011 L 35
8400 motec | Software Manual
Device control (DCTRL)
Device commands (C00002/x)
4.1.1 Load Lenze setting
The C00002/1
= "1: On / start" device command resets the parameters to the Lenze setting
which are saved in the controller Firmware.
 Can only be executed if the controller is inhibited; otherwise, the feedback C00002/
1 = "6: No access - controller inhibit" will be returned.
 All parameter changes which have been carried out after the last time the parameter
set was saved will be lost!
 This controller command has an effect on the settings of the parameters of the
operating system, application and module.
 How to load the Lenze setting:
1. If the controller is enabled, it must be inhibited, e.g. by executing the "Enable/
Inhibit controller" device command (C00002/16
= "0: Off / ready").
2. Execute the "Load Lenze setting" device command:
C00002/1
= "1: On / start"
The load process may take a couple of seconds. After the device command has been
called in C00002/1
, a dynamic status information ("Work in progress"  "Off /
Ready") is returned.

Lenze 8400 motec Specifications

General

Input Voltage	3-phase 380V to 480V AC
Control Mode	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, short-circuit, overtemperature
Relative Humidity	≤ 95 %, no condensation
Altitude	Up to 1000m above sea level
Storage Temperature	-20°C to 65°C